In a previous blog post, we showed how OnePager Pro and Express 5.1 can prepare multi-page project views. In this blog post, we are going to show how you can add and remove page breaks to a project view to suit you specific needs.
First off, the controls for adding and removing page breaks can be found on the Page Layout tab in the in the Page Setup section as shown below:
Selecting this button causes a drop down menu to appear as shown below:
You may insert a manual vertical or horizontal page break at any time. The two Remove all page break options are only active when there are page breaks available to remove.
Clicking the Insert vertical page break option gives you a cursor that will drop a horizontal page break between any two rows. This is shown below:
Once the vertical page break is positioned, the project view will look like this when viewed in the OnePager 5.1 Page Break View mode:
The exact same process can be used for inserting horizontal page breaks. Repeating the process allows you to insert as many page breaks as needed.
Removing page breaks requires the selection of one of the two Remove all page break options shown in the illustration above.